Ultra Pure 5 Stage Reverse Osmosis Water Filter System + Di (300 GPD)

5 Stage Eco Ultra Pure Reverse Osmosis Water Filter System + Di producing 300 Gallons of Water Per Day

This is a high quality reverse osmosis water filter system which removes a wide range of harmful contaminants from your supply water like chlorine, heavy metals, fluoride, pesticides, bacteria, silt and microplastics. Purifying the water to zero (TDS) total dissolved solids with the aid of the post di resin filter. Dual membrane system to reduce waste water and boost pure water production.

This system can fit neatly in to your underink cupboard or in tight fit spaces. No plumbing skills are required as arrives with everything you need to install with full instructions.

Typical use of the 4 stage di : Marine Fish Keeping, Autoclaves, Car/Window Cleaning, Vodka Production, Hydroponics. (Di systems are not suitable for drinking water - Please see other ranges)

Benefits

Removing up to 99% of tap water contaminants including bacteria and viruses

Dual Membranes reduce waste water by up to 50% and increase pure water production by up to 95% (The waste water line from the first membrane does another pass through the second membrane)

Superior high capacity 10 inch sediment, carbon block and (GAC) granular activated carbon Pre-filters

Excellent reduction in total dissolved solids (TDS)

RODI systems benefit from a large post deionization process to filter mineral salts to guarantee 0ppm TDS

Ideal for collecting purified water for home use or aquarium systems


Features

Pre-assembled and supplied with all the fitting accessories

Includes a built in membrane flush system which reduces fouling to extend membrane life

Arrives with a built in pressure gauge as standard providing a visual on inlet water pressure

Can be floor standing or wall mounted

Filter Stages

Stage 1 - Sediment Pre-Filter: For the removal of sediments, dirt, sand and rust.

Stage 2 - Carbon Block Pre-Filter: removes chlorine and organic chemicals that contribute to bad taste and odours.

Stage 3 & 4 - Dual Membrane: Reverse Osmosis membranes are semi-permeable removing up to 99% of contaminants present in water including viruses, bacteria, heavy metals, fluoride, hormones, silica and salts.

Stage 5 - DI Resin Post Filter: reduces Total Dissolved Solids (TDS) to 0ppm and designed as a final polisher for the production of pure water

All reverse osmosis systems are shipped fully assembled, it is simple enough to insert filters and connect to a water supply and waste water drain.

Downloads section below for RO Unit Set Up, installation and maintenance guidance, and we provide technical and sales support.

{Whats in the box!}
The RO System includes
2 x 150 US gallon per day membrane
1 x 5 micron Sediment Pre-filter
1 x Carbon Block Pre-filter
1 x Large Deionization Post Filter
1 x Pressure Gauge
1 x Feed Water Clamp
1 x Waste Water Clamp
1 x Filter Housing Wrench
2 x Metres of 1/4" Red Tubing
2 x Metres of 1/4" Green Tubing
2 x Metres of 1/4" Blue Tubing
1 x Membrane Flush Kit

{More Info}

Dimensions: (mm) H 385 x W 375 x D 160
Inlet/outlet: !/4"

The effectiveness and productivity of RO systems increase with greater water pressure and temperature. The actual flow rate (in GPD) of any reverse osmosis system depends on your home water pressure and temperature.

Manufacturers recommend 60 psi is required at the membrane for full production, not everyone's cold water is at 60 psi and 77 degrees F; therefore, you might get less than 50 GPD, perhaps 50% or even less if your pressure and temperature are very low! Please consider these factors before you finally decide on which system is best for you.

Filter Replacement

Pre-filters should be replaced every 6 months or 2500 gallons (or when visibly dirty). If any of your pre filters are exhausted, using the unit will put additional pressure on the membrane. Filters are much cheaper to replace than a damaged membrane, which are also available on the website.
{Downloads}


{Replacement Filters}


{Delivery Info}
We endeavor to process and despatch your orders as quickly as possible and orders placed before 1pm are normally despatched the same day to arrive next working day (Highlands and Islands deliveries normally take 1-2 days longer).

Your order will be delivered via a 3rd party courier or delivery service on a next working day delivery service. We recommend that you ensure you have received your order prior to booking any installers.

All orders come with full tracking details and you can keep an eye on your delivery by using the tracking button at the top of the website.