Aquarius 5 Stage LCD Reverse Osmosis Water Filter System + Di (100 GPD)

Product ID:

623

Price:£194.95

Quantity:

Add Extra Set Of Pre-Filters

Add Pressure Gauge?

Want it by Friday, 6 June
Order within 23 hours 58 minutes 1 second

This is a high quality 100 GPD boosted reverse osmosis water filter system with LCD which removes a wide range of harmful contaminants from your supply water like chlorine, heavy metals, fluoride, pesticides, bacteria, silt and microplastics. Purifying the water to zero (TDS) total dissolved solids with the aid of the post di resin filter.

LCD Controller - Dual TDS Monitoring - Auto & Manual Overide Flush - Filter Life Countdown

Self-Regulating Booster Pump

5 Stage Of Purification

Leak Detection Alarm

ZERO TDS

This system can fit neatly in to your undersink cupboard or in tight fit spaces. No plumbing skills are required as arrives with everything you need to install with full instructions.

Operated via LCD display that shows when membranes (filters) should be replaced, Water temperature, PPM reading and the opportunity to auto flush the system through the LCD display.

It also comes with a Leak system detector that can be placed where you want it.

Typical use of the 5 stage di : Marine Fish Keeping, Autoclaves, Car/Window Cleaning, Vodka Production, Hydroponics. (Di systems are not suitable for drinking water).

Benefits

Removing up to 99% of tap water contaminants including bacteria and viruses

Superior high capacity 10 inch 5 and 1 micron sediment, carbon block (CTO) pre filters

Excellent reduction in total dissolved solids (TDS)

RODI systems benefit from a post deionization process to filter mineral salts to guarantee 0ppm TDS

Ideal for collecting purified water for home use or aquarium systems

Features

Pre-assembled and supplied with all the fitting accessories

Arrives with a built with booster pump and LCD Display/Controller

Can be floor standing or wall mounted

Filter Stages

Stage 1 - 5 Micron Sediment Pre-Filter: For the removal of sediments, dirt, sand and rust.

Stage 2 - Carbon Block Pre-Filter: removes chlorine and organic chemicals that contribute to bad taste and odours.

Stage 3 - 1 Micron Sediment Pre-Filter: For further removal of smaller sediments, dirt, sand and rust.

Stage 4 - Membrane: : Reverse Osmosis membranes are semi-permeable removing up to 99% of contaminants present in water including viruses, bacteria, heavy metals, fluoride, hormones, silica and salts.

Stage 5 - DI Resin Post Filter: reduces Total Dissolved Solids (TDS) to 0ppm and designed as a final polisher for the production of pure water

All reverse osmosis systems are shipped fully assembled, it is simple enough to insert filters and connect to a water supply and waste water drain.

The RO System includes
1 x 5 stage water filter system
1 x 100 GPD booster pump
1 x LCD controller/display
1 x 100 US gallon per day membrane
1 x 5 micron sediment pre-filter
1 x Carbon block pre-filter
1 x 1 micron sediment pre-filter
1 x Deionization post filter (clear or white housing subject to stock)
1 x Feed water clamp
1 x Waste water clamp
1 x Filter housing wrench
1 x 5m of 1/4" tubing
1 x leak detection kit
1 x instructions

The effectiveness and productivity of RO systems increase with greater water pressure and temperature. The actual flow rate (in GPD) of any reverse osmosis system depends on your home water pressure and temperature.

Manufacturers recommend 60 psi is required at the membrane for full production, not everyone's cold water is at 60 psi and 77 degrees F; therefore, you might get less than 50 GPD, perhaps 50% or even less if your pressure and temperature are very low! Please consider these factors before you finally decide on which system is best for you.

Filter Replacement

Pre-filters should be replaced every 6 months or 2500 gallons (or when visibly dirty). If any of your pre filters are exhausted, using the unit will put additional pressure on the membrane. Filters are much cheaper to replace than a damaged membrane, which are also available on the website.

We endeavor to process and despatch your orders as quickly as possible and orders placed before 1pm are normally despatched the same day to arrive next working day (Highlands and Islands deliveries normally take 1-2 days longer).

Your order will be delivered via a 3rd party courier or delivery service on a next working day delivery service. We recommend that you ensure you have received your order prior to booking any installers.

All orders come with full tracking details and you can keep an eye on your delivery by using the tracking button at the top of the website.